![]() ![]() In case you want to write all the data to a file, you will have to use additional arguments: If you want to filter by BSSID, then you should put: If you want to filter by WiFi networks with WPA, then you must put the following command: In the case that it is WPA2 AES, we have to change the -za value to 4, in this way: wlan0: is the physical interface of the WiFi card.Although we could also use 4 to use CCMP (WPA2 with AES). If we want to create a fake access point called “this article” to capture the WPA handshake, we have to enter the following command:Īirbase-ng -c 9 -e this article -z 2 wlan0 The options that we have available in airbase-ng are very broad, so we are going to indicate the main commands that we can use to carry out certain specific actions. Because of this, real APs around us may be disrupted by doing this attack, so it would be advisable to use filters to minimize this “damage” to other APs. The AP will respond to any poll request with an appropriate poll response, thus telling clients to connect to the BSSID of airbase-ng. Real clients will send probe requests for configured networks, and these frames will allow us to bind clients to our Fake AP that we configured. The goal of this program is for clients to associate with the Fake AP, not the real access point. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |